Description

This listing is for a new open box, DX Engineering DXE-LLSP Ladder Feed Line Surge Protector. See below for manufacturers specs and product information. Buyer pays $7.00 USPS shipping and handling. DX Engineering Ladder Line Surge Protector Built by popular demand, the DX Engineering Ladder Line Surge Protector is ready to be placed in line with your balanced feedline antenna system! For many years, hams have asked us for a surge protector for use with their 300 ohm and 450 ohm ladder line fed antennas. Decades ago automotive spark plugs or arc gaps were used for shunting lightning pulses from balanced feeders to ground. But, you never really knew if they were going to work, if they really were continuing to work or if they were affecting the tuning. Here is the modern approach to providing surge protection for ladder line fed antennas. Made with components similar to those used in coaxial protectors, the DXE-LLSP uses much larger capacitors, resistors and gas discharge tubes on each leg of the ladder line to offer excellent surge protection capabilities at high SWR. These components are rated to handle 5 kW, so this protector will easily handle well over legal limit RF power at the high standing wave ratios expected on balanced line. Plus, the Ladder Line Surge Protector bleeds off the static charge that is collected on your antenna from wind driven sand, rain and snow! The DXE-LLSP Ladder Line Surge Protector is built to sustain multiple minor surges. As with any surge protector, there is no guarantee that a direct hit from lightning will be stopped. A replacement parts kit is also available to refurbish your pulse damaged protector: DXE-LLSP-RP Features of the DX Engineering Ladder Line Surge Protector: • Standard size NEMA enclosure; 4 x 4 x 2 in. nominal box dimensions; mounting tab holes on centers: 4.625 x 2.125 in. • Works with 450 ohm or 300 ohm Ladder Line and 600 ohm open-wire feeder • Internal Gas Discharge Tubes, Capacitors and Resistors • Can withstand multiple minor surges and shunts them to ground • Bleeds off static charge collected from wind driven snow, rain and sand • Weep holes allow any buildup of internal moisture to drain out • Handles well over legal limit at high SWR as expected on balanced line NOTE: The DXE-LLSP is an RF only device that does not carry DC voltage. Therefore it cannot be tested with a multimeter. It must be tested with an analyzer and a 300 ohm resistor, or by connecting an antenna feedline. If there is infinite SWR or no receive, the components have been damaged by lightning pulse energy and need to be replaced with the DXE-LLSP-RP Ladder Line Surge Protector Replacement Parts Kit. Order the DX Engineering Ladder Line Surge Protector for your balanced feedline antenna system today!